- PLS CADD USER MANUAL WIRE PORTABLE
- PLS CADD USER MANUAL WIRE SOFTWARE
- PLS CADD USER MANUAL WIRE PLUS
Thank you very much 'transmissiontowers'. RE: PLS CADD (Structural) 12 Feb 13 11:21. _ I have been called 'A storehouse of worthless information' many times. With the new tower's weight and wind span parameters because the spans could change with the new O.S. Now, if the selected tower is not strong enough and you have to replace it with a slightly taller one, then you need to re-run the O.S. You then string all your wires and do the structural analysis to make sure the towers are indeed strong enough. I believe it assumes that the tower/pole will be strong enough based on the simple parameters you input.
You then run O.S.Īnd it picks a set of towers or poles based on the cheapest line design.
PLS CADD USER MANUAL WIRE PLUS
You identify the hard angle points where the line turns, then you identify a set of possible candidate structures with their capacities in wind and weight spans plus the max angle. From my meager understanding, you start with a route you have terrain data for. The manual is fairly good and it would be good to get a basic understanding by reading the manual and opening the example line models and see how the O.
PLS CADD USER MANUAL WIRE SOFTWARE
If you have a senior engineer around that has experience with the software and the optimum spotting, lean on their experience. From my experience, there is a lot to learn about the software. Thanks a lot RE: PLS CADD (Structural) 11 Feb 13 20:45. Regarding the PLS-CADD line design I´d like to deepen a little bit more before, in order to make the most of it. I´ll follow your advice and I´ll contact PLS Tech Support. If an structure does not fit, I set manually another on its place. So after selecting the possible structures and once I´ve simulated them with one single conductor (what would it happen if terrain has got and slope?), I have got to string the other wires and calculate strengths. Thank you very much 'transmissiontowers', I thought maybe using PLS Tower I could generate a simplified model to be used by the Optimum Spotting. You should also think about signing up for the PLS-CADD line design course. You can get much more detailed answers by calling PLS Tech support. Is done, then you string wires, fiber, OGW and check the strength of the towers. The program only needs 1 ckt to check the spotting because it is only looking at the sag of the lowest wire. The towers have a wind and weight span specified and the program picks the cheapest set of towers that make up the line. I don't believe it takes the strength of the towers into account when doing O.S.Įxtruder Operator Manual. Algorithm only looks at ground clearance over the terrain and does the spotting to find the lowest cost for a line.
PLS CADD USER MANUAL WIRE PORTABLE
Ingersoll Rand Portable Air Compressor Manual.
I'm a structural guy and we don't use optimum spotting but from the demo I saw a few years ago the O.S. Thanks a lot RE: PLS CADD (Structural) 9 Feb 13 00:26. Because to simulate optimum spotting assigning differents towers it has got to take into account 2 circuit and fibre´s forces.
0 kommentar(er)
